Path: news1.icaen!news.uiowa.edu!news.physics.uiowa.edu!math.ohio-state.edu!news.cis.ohio-state.edu!news.maxwell.syr.edu!news-peer.sprintlink.net!news.sprintlink.net!Sprint!newsfeed.internetmci.com!207.5.0.44!nntp.mainstreet.net!feeder.swcp.com!fugu!lynx.unm.edu!mirac.unm.edu!buggie From: buggie@mirac.unm.edu (stephen e buggie) Newsgroups: comp.sys.apple2 Subject: Re: mono monitor fuse Date: 10 Feb 1998 20:55:19 GMT Organization: University of New Mexico, Albuquerque Lines: 34 Message-ID: <6bqern$2438$1@lynx.unm.edu> References: NNTP-Posting-Host: mirac.unm.edu X-Newsreader: TIN [version 1.2 PL2] Xref: news1.icaen comp.sys.apple2:130101 I dont have specific advice, but I had ONE green Monitor II blow a fuse. I installed a panel-mounted fuseholder on the back of the plastic casing so that, in the future, I could replace the fuse without going inside. The Monitor II casing is roomy so placing the panel mounted fuseholder was easy. MEMORY PLUS distributors is selling used Monitor II's for $7.50 each plus shipping; why not scrap the bad one you have and get a good one? Platinum Monitor II's are just $10.00 plus shipping. I've dealt withMemory Plus before, and they are reliable and accurate. Memory Plus's ad is listed under CROW FRED; they are located in Phoenix AZ. Steve Buggie Gallup NM dave (dave@sbi-online.com) wrote: : Hi : I have an old green mono monitor for a IIc, and the 1.5a fuse on the : bottom board keeps blowing on power up. Does anyone have a clue what to : look for? I am suspecting a suspicious looking resistor nearby. : Please respond via e-mail: ddgx@sgi.net or dave@sbi-online.com : Thanks, : dave