the Apple-1 Cassette Interface Card    Page No.:A10
 
         
     
  The Apple-1 did not have a interface "on board" to store or read programs. At the moment the computer had been developed, Steve Wozniak
  of course was aware of that problem - so he integrated the slot at the edgeconnector with the most signals of the Apple-1 looped up to the slot.
 
  This gave him the freedom to first complete the design of the computer itself and push the development of the "storage facility"  ahead to a later
  point in the timeline. While then testing the basic functions of the Apple-1 prototype he then searched for a cheap and simple ability to store
  and read programs and then designed the Apple-1 cassette interface. This gave the user a cheap and common ability to handle the storage. You
  should remember that the common storage units of those days on disk or at cards have been extreme expensive and due to the fact that Wozniak
  and Jobs targeted in the general to sell their computer to students - so they of course did hunt for a cheaper solution to problem of that days. At
  the other hand cassette tape recorders and tapes had already become very common in that days and had been availiable at an affordable price.

 
         


  The cassette interface was sold on those days slightly below $80.- and due to the low prive the design had to be as simple and cheap as possible.
  The circuitplan below uncovers that 3 logic chips and 1 opamp the most work was performed by the software left in 2 ROM-chips organized in the
  order like on the mainboard as upper half byte and lower half byte adding up together to the entire byte. The advertisement displays the low price
  of the interface card.
 

  
   
        

   The Operation manual of the ACI is rather simple and short. It consisted of only 2 sheets of folded paper and wrapped down to half letter size.
 

        
       
   

  Please also recognize the red marked area in page 4 !
  the remark remind the user that at the mainboard a jumper must be added at the adressing-selection area ( in the canter at the 74154 )
  to ensure correct operation of the cassette interface.

   In the meantime the Software routines of the Apple-1 Cassette Interface has been disassembled by members at Applefritter.com and here is just the overview
   of that disassembly:
 

  
   
 
   
 
   
 


 
         
         
         
         
       due to european laws and german court decision:
 I hereby declare no responsibility to any "deep links" resulting from the links in this page. I have no influence to the pages linked hereby in this page and the
 contents in those pages. I therefor canīt take any kind of responsibility to contents in the pages, where these links direct the readers browser to nor to the
 contents resulting from following up links from those pages. The reference to contents by this links is dependent ro the status of the date when the links have
 been set ( April 2013 ) and it might occur that references and contents may change by the fact that domains may have been discontinued from their former owners.
 In such cases i canīt take any kind of responsibility to the changed contents. this is specialy valid to banners, advertisements or merchandising links in the targeted
 pages.